The Vulnerability of the Pitot Tube to Insect Obstruction
A small blockage in the pitot-static system can render airspeed indications dangerously misleading during critical phases of flight like takeoff and landing.
Drafted with AI assistance from a short brief. Reviewed and published by Dmitry Shteyn.
At airports across Wisconsin, particularly during the transition from autumn to winter, the pitot tube faces a persistent threat from small insects and debris. This narrow, forward-facing opening is the sole source of total pressure for the airspeed indicator. If a mud dauber or spider builds a nest inside the tube while the aircraft is parked at an airport like Kenosha Regional, the system is compromised before the engine even starts. Because the airspeed indicator relies on the difference between ram air pressure from the pitot tube and static air pressure from the static port, any blockage fundamentally alters the instrument's physics.
Consider a scenario where the pitot tube is completely blocked but the drain hole remains open. In this case, the pressure inside the line will bleed out, and the airspeed indicator will drop to zero, even as the aircraft accelerates down the runway. A more insidious failure occurs when both the pitot opening and the drain hole are blocked. The system becomes a sealed chamber, trapping the air pressure that was present at the moment of the blockage. As the aircraft climbs into thinner air, the static pressure outside the diaphragm drops, but the internal pressure remains constant. The instrument will behave like an altimeter, showing an increase in airspeed as you climb and a decrease as you descend, regardless of your actual velocity through the air.
In the cockpit, these errors are not always immediately obvious. A pilot might see a normal-looking airspeed during the initial climb and fail to realize the needle is moving in response to altitude rather than thrust or pitch. This can lead to a stall if the pilot raises the nose to correct for what they perceive as excessive speed. Verification of airspeed early in the takeoff roll is the primary defense against this system failure.
Hazard Warning: If the airspeed indicator fails to show a positive and logical increase during the first third of the takeoff roll, the takeoff must be aborted immediately to prevent departing the ground with unreliable flight data.